Burst Pipe? Turn the Water Off, Do Not Patch It

Burst Pipe Turn The Water Off

Table of Contents

When a burst pipe starts spraying, the instinct is to grab whatever might plug it. Resist it. Shut the water off at the stop tap beside your meter, then stop: a clamp, tape or epoxy putty is a hold rather than a repair, and the repair itself is licensed work in Victoria. 

That is not just a plumber’s opinion. Greater Western Water, the water corporation for Werribee and the rest of Wyndham, tells its own customers to use the stop tap at the meter in exactly this situation. Here is what to do, what to leave alone, and why. 

Key Takeaways 

  • Close the stop tap at your water meter first. 
  • Turn off the water to the hot water unit, drain the line, and cut power if water is near wiring. 
  • Photograph everything before anyone touches it. 
  • A clamp or putty only holds. It does not fix the pipe. 
  • In Victoria, plumbing work over $750 needs a licensed plumber and a compliance certificate. 

What is the first thing to do when a pipe bursts? 

Greater Western Water’s Residential Customer Charter 2024 to 2028 explains that the stop tap controlling water to the house is normally located with the water meter, and that “In an emergency, such as a burst pipe, you can use this stop tap to turn off the water supply to the house.” The meter is usually near the front of the property, often just inside the boundary or fence line. 

Then work through these steps: 

  1. Find the stop tap at the meter and close it. This stops water entering the house. 
  1. Shut the water supply to the hot water unit. Close its own isolation valve so it does not keep feeding the leak. 
  1. Open the lowest cold taps to drain the line. This lets water left in the pipes run out through a tap rather than the burst. 
  1. Kill power at the board if water is near wiring. Only do this if you can reach the switchboard without standing in water. 
  1. Photograph everything before anyone touches it. The burst, the water damage and the meter reading all help later. 


Once the water is off, call a licensed plumber. Our team handles burst pipe repair in Werribee, and you can reach an emergency plumber in Werribee when it cannot wait. 

Will a hose clamp or epoxy putty actually hold? 

For a while, sometimes. Many owners say a clamp over a strip of rubber is a fair temporary fix, and some leave one in place for months. It is a fair point: a clamp genuinely does slow a leak, and when the burst is outside and the household needs water back on, people reach for one. 

But a hold is not a repair. The limits are worth knowing: 

  • A clamp or putty sits on the outside of a pipe that has already failed. 
  • A corroded pipe can fail again right beside the clamp. 
  • None of it tells you why the pipe burst in the first place. 


If a pipe has been weeping for a while before it gave way, our post on why that small leak never stays small explains what tends to happen next. 

Why is the repair not a DIY job in Victoria? 

Because fixing the pipe is plumbing work, and Victorian law sets rules for who does it. The Building and Plumbing Commission explains that Part 12A of the Building Act 1993 sets out the requirements for compliance certificates. 

In practice: 

  • A compliance certificate must be issued by a licensed plumber for certain plumbing work in Victoria. 
  • One is required where the total value of the work, including materials, appliances, labour and GST, exceeds $750. 
  • The certificate is your record that the work meets the relevant plumbing standards. 


GWW’s own charter makes the same point from the other side: if you have an internal leak, you will need to call a plumber to have it repaired. 

What if I cannot turn the water off? 

Sometimes the meter is missing, buried or hard to reach. GWW’s charter covers these cases: 

  • No meter, or an inaccessible meter. GWW’s responsibility runs up to and including the first accessible stop tap no more than two metres inside your property boundary. That tap is the one to look for. 
  • The pipe is on GWW’s side. GWW is responsible for the meter and the property service pipe up to it, when the meter sits within two metres of the title boundary that abuts the water main. Past the meter, the pipe is the owner’s. 
  • The stop tap will not turn, or the leak is at or before the meter. Call GWW’s 24-hour faults and emergencies line on 13 44 99. 


If the water is off but you cannot see where it is coming from, leak detection can find it without guesswork. 

What to check before any exploratory work? 

Finding a hidden burst can mean opening a wall, lifting a floor or digging. Before any of that starts: 

  • Tell your insurer first. Some policies have conditions about notice and approval before work begins. 
  • Read your product disclosure statement (PDS). It sets out what your own policy says about water damage and how to claim. 
  • Keep your photos and receipts together. The pictures from step 5 are part of that record. 


Only your insurer and your policy wording can tell you what is covered. 

How fast does water damage get expensive? 

Faster than most people expect, because water keeps moving after you stop looking at it. It soaks into plasterboard, timber and floor coverings, and spreads under surfaces you cannot see. The longer it runs, the more materials it reaches, and the more has to dry out or be replaced. 

That is the real case for the stop tap. Every minute it stays open adds water to the bill, and closing it is the one step that costs nothing. Water that reaches a hot water system can bring its own problems too, covered in our guide to emergency hot water repairs. 

FAQs 

Can I fix a burst pipe myself? 

You can and should close the stop tap. The repair itself is plumbing work, and in Victoria work over $750 needs a licensed plumber and a compliance certificate under Part 12A of the Building Act 1993. 

Who is responsible for a burst pipe? 

Where the meter sits within two metres of the boundary, GWW looks after the meter and the pipe up to it, and the owner is responsible for the pipe beyond it. If you rent, a burst water service is legally an urgent repair. According to Consumer Affairs Victoria, if the rental provider does not act, renters can arrange the repair up to $2,500 and must be repaid within 7 days of giving written notice. 

Is a burst pipe an emergency? 

Yes. Close the stop tap straight away, then get a licensed plumber to the pipe. 

The bottom line 

Shut the water off at the stop tap beside your meter, then stop. A clamp, tape or epoxy putty is a hold rather than a repair, and the repair itself is licensed work in Victoria. 

When the pipe is fixed, it is worth asking whether the rest of the line is sound. For damaged underground pipes, pipe relining can be an option worth discussing. To book a licensed plumber, contact us. 

Picture of Plumber in Werribee

Plumber in Werribee

Share this article

Have a Question?

Feel free to discuss with one of our friendly team member.

Related Topics

Get a Free Quote